Miller Electric Big Blue 400 PX Welding System User Manual


 
OM-229 979 Page 23
5-6. Engine Prestart Checks
. Check all engine fluids daily.
Engine must be cold and on a level surface.
Unit is shipped with 20W break-in oil.
Automatic shutdown system stops engine if
oil pressure is too low or coolant tempera-
ture is too high.
. This unit has a low oil pressure shut-
down switch. However, some condi-
tions may cause engine damage before
the engine shuts down. Check oil level
often and do not use the oil pressure
shutdown system to monitor oil level.
Follow run-in procedure in engine manual.
If unburned fuel and oil collect in exhaust
pipe during run-in, see Section 10.
Fuel
NOTICE Do not use gasoline. Gasoline
will damage engine.
The unit is shipped with enough fuel to pre-
vent air from entering fuel system. Add fresh
diesel fuel before starting (see engine main-
tenance label for fuel specifications). Leave
filler neck empty to allow room for
expansion.
Do not run out of fuel or air will enter fuel sys-
tem and cause starting problems. See en-
gine manual to bleed air from fuel system.
Oil
After fueling, check oil with unit on level sur-
face. If oil is not up to full mark on dipstick,
add oil (see maintenance label).
Coolant
Check coolant level in radiator before start-
ing unit the first time. If necessary, add cool-
ant to radiator until coolant level is at bottom
of filler neck.
Check coolant level in recovery tank daily.
If necessary, add coolant to recovery tank
until coolant level is between Cold Full and
Hot Full levels. If recovery tank coolant level
was low, also check coolant level in radiator.
Add coolant if level is below bottom of radia-
tor filler neck.
Unit is shipped with an engine coolant mix-
ture of water and ethylene glycol base anti-
freeze rated to 34° F (37° C). Add anti-
freeze to mixture if using the unit in tempera-
tures below 34° F (37° C).
Keep radiator and air intake clean and free
of dirt.
NOTICE Incorrect engine temperature
can damage engine. Do not run engine with-
out a properly working thermostat and ra-
diator cap.
. To improve cold weather starting:
Use Preheat switch (see Section 6-2).
Keep battery in good condition. Store
battery in warm area.
Use fuel formulated for cold weather
(diesel fuel can gel in cold weather).
Contact local fuel supplier for fuel in-
formation.
Use correct grade oil for cold weather
(see Section 8-1).
Full
Capacity:
6 qt (5.7 L)
Diesel
Full
Hot Full
Cold Full
Check radiator coolant
level when fluid is low in
recovery tank.
Coolant Recovery Tank
Ref. 804 009C
Full