Filter
Top Products
OM-229 979 Page 24
5-7. Connecting To Weld Output Terminals
Tools Needed:
3/4 in
Ref.804 630-A / Ref. 229 747-A / 803 778-A
6
4
5
Do not place
anything between
Correct Installation
Incorrect Installation
3
weld cable terminal
and copper bar.
! Stop engine.
1 Work (−) Weld Output Terminal
2 Positive (+) Weld Output Terminal(s)
! Failure to properly connect weld
cables may cause excessive heat and
start a fire, or damage your machine.
3 Weld Output Terminal
4 Supplied Weld Output Terminal Nut
5 Weld Cable Terminal
6 Copper Bar
Remove supplied nut from weld output termi-
nal. Slide weld cable terminal onto weld output
terminal and secure with nut so that weld cable
terminal is tight against copper bar. Do not
place anything between weld cable termi-
nal and copper bar. Make sure that the sur-
faces of the weld cable terminal and cop-
per bar are clean.
Stick and TIG Welding
For Stick and TIG welding Direct Current Elec-
trode Positive (DCEP), connect electrode
holder cable to Positive (+) terminal and work
cable to Negative (−) terminal on left.
For Direct Current Electrode Negative
(DCEN), reverse cable connections.
Use Process switch to select type of weld out-
put (see Section 6-3).
MIG and FCAW Welding
For MIG and FCAW welding Direct Current
Electrode Positive (DCEP), connect wire
feeder cable to Positive (+) terminal and work
cable to Negative (−) terminal on left. Use Pro-
cess switch to select type of weld output (see
Section 6-3).
For Direct Current Electrode Negative
(DCEN), reverse cable connections.
1
2