Filter
Top Products
OM-699 Page 5
3-3. Installing Optional Light Kit
ST-802 074
Y Support trailer with jack. Block
wheels.
1 Wiring Harness White Ground Lead
Secure ground lead ring terminal to the chain
bracket using 1/4-20 x 3/4 hardware.
2 Grommet
Locate holes for routing wire near each tail-
light. Insert grommet in each hole.
Route brown and green leads along right in-
side of frame to end of trailer. Route brown
and yellow leads along left side.
Strip 1/2 in (12.7 mm) insulation from ends of
brown, green, and yellow leads.
3 Taillight
Insert stripped end of green lead into right tail-
light hole marked STOP & TURN (GREEN).
Insert stripped end of yellow lead into left tail-
light hole marked STOP & TURN (YELLOW).
Insert stripped end of brown leads into TAIL
(BROWN) holes in each light.
Mount lights on brackets using supplied 1/2
nuts.
4 Sidelight
Pull a small length of brown lead thru hole in
side of trailer.
Splice sidelight short lead to wiring harness
brown lead using supplied tab connector (see
Section 3-4).
Secure sidelight to frame as shown.
Install other sidelight the same way.
LEFT
RIGHT
To TrailerTo Vehicle
Sidelight
Ground
(White)
Taillights
(Brown)
Right Stop/
Signal Lamps
(Green)
Taillights
Tools Needed:
3/8, 7/16 in
Wiring Connections:
Green Lead
1
2
3
Brown Lead
Brown Lead
Yellow Lead
Sidelight
White Ground Lead
(Ground To Trailer Frame)
Short Lead
Left Stop/
Signal Lamps
(Yellow)
Short Lead
Tab Connectors
4
Insert Green Lead
Insert
Brown
Lead