Filter
Top Products
OM-699 Page 6
3-4. Installing Wiring Harness Tab Connectors
Disconnect vehicle wiring harness plug from trailer wiring connector before
beginning installation. Use wiring harness tab connectors only with insulated wires.
NOTE
1 Connector
2 Run Wire
3 Tap Wire
Place unstripped run wire in slotted
channel.
Insert unstripped tap wire into other
channel until it hits internal stop.
4 Contact
5 9 Inch Linemans Pliers
Use pliers to push contact down
flush with top of connector.
Close top cover.
Ref. S-0448
1
2
3
4
5
3-5. Installing Welding Generator
Y Use equipment of adequate
capacity to lift the generator.
Y Support trailer with jack. Block
wheels.
Y If trailer is not installed on ve-
hicle, use trailer jack to obtain
desired height and to support
tongue weight while installing
welding generator.
Y Install welding generator on
trailer with engine end toward
hitch end of trailer.
Y Distribute weight so trailer
tongue weight is approximate-
ly 10% of gross trailer weight.
1 Crossmember Mounting Holes
Use supplied hardware to install gen-
erator so front panel faces rear.
Move crossmembers to correct posi-
tion on trailer frame so mounting
holes align with welding generator
holes. Crossmembers should be ad-
justed so tongue weight is 10 − 15%
of gross trailer weight.
Tighten crossmembers and secure
generator.
Tools Needed:
9/16 in
ST-802 067
1
1