Filter
Top Products
OM-6611 Page 7
3-2. Mounting Wheels And Brackets On Axles
802 812
. Use hardware in Red bag to
mount wheels.
1 Wheel
2 Hub
3 Lug Nut
Install wheels on hubs. Install lug
nuts and tighten to 70 ft lb (95 N
.
m).
4 Mounting Bracket
5 1/2-13 x 1-1/2 in Screw
6 1/2 ID Flat Washer
7 1/2 ID Lock Nut
Attach mounting brackets to brack-
ets on axle. Save remaining hard-
ware to mount unit on trailer (see
Section 3-7).
. Do not tighten hardware until
unit is mounted on trailer (see
Sections 3-7 and 3-8).
3/4, 13/16 in
Tools Needed:
2
1
3
4
5
6
7
3/4 in
6
3-3. Mounting Axle On Frame
All directions are given as facing the towing vehicle. The word “front” means the
hitch end of the trailer.
NOTE
802 813
1 Axle Assembly
2 Welded Stop
3 Frame
4 Plate
5 3/8-16 x 4 in Screw
6 3/8 ID Flat Washer
7 3/8 ID Lock Nut
Position frame against the right side of
the welded stop on the axle. Attach
axle to frame using supplied hardware.
Tighten hardware to 30 ft lb (41 N
.
m).
8 Jack
Pull pin and rotate jack to vertical posi-
tion. Pin locks jack in place. Turn han-
dle to raise or lower trailer.
When jack is not needed, pull pin and
rotate jack to horizontal position.
9/16 in
Tools Needed:
4
1
3
5
7
8
9/16 in
2
6
6