Filter
Top Products
OM-223 605 Page 11
SECTION 4 − INTRODUCTION
4-1. Specifications
Type of Input
Power
Welding Power
Source Type
Welding
Circuit
Rating
IP
Rating
Overall
Dimensions
Maximum
Spool Weight
Wire Feed
Speed Range
Wire
Diameter
Range
Weight
24 Volts ac
Single-Phase
10 Amperes
50/60 Hertz
Constant
Voltage (CV)
DC With 14-Pin,
that Provides
Voltage and
100 Volts,
750 Amperes,
100% Duty
Cycle
IP 21 Length: 27 in
(686 mm)
Width: 12-1/2 in
(318 mm)
Height: 14 in
60 lb
(27 kg)
Standard
Speed: 50 to
1400 ipm (1.3
to 35.6 mpm)
.023 to 5/64 in
(0.6 to 2.0
mm)
43 lb
(19.5 kg)
Voltage and
Current
Feedback
Height: 14 in
(356 mm)
Low Speed:
20 to 400 ipm
(0.5 to 10.1
mpm)
.023 to 1/8 in
(0.6 to 3.2
mm)
48 lb
(21.7 kg)
SECTION 5 − INSTALLATION
802 806-A
Y Do not put feeder where
welding wire hits cylinder.
Y Do not move or operate
equipment when it could tip.
1 Wire Feeder
2 Rubber Feet
Choose slot that allows all rubber
feet to sit securely on top of welding
power source.
3 Wire Spool/Reel
4 Gas Cylinder w/Hose And
Regulator (Customer
Supplied)
. Shielding gas pressure not to
exceed 90 PSI (620 kPa).
5 Welding Power Source
6 Running Gear
1
3
5
4
2
5-1. Site Selection
Wire feeder shown is
representative only and does
not reflect actual unit.
6