Milwaukee 2411-059 Cordless Drill User Manual


  Open as PDF
of 20
 
17
The torque specifications shown here are ap-
proximate values obtained with a fully charged
battery pack.
NOTE: Because the settings shown in the table are
only a guide, use a piece of scrap material to test
the different clutch settings before driving screws
into the workpiece.
TorqueSpecicationsforCat.No.2411-059
Clutch
Setting in.lbs
Applications
1-5
6-10
11-15
16-18
5-15
16-22
23-28
29-40
Small screws in softwood.
Medium screws in softwood or small
screws in hardwood.
Large screws in softwoods. Medium
screws in hardwood or large screws in
hardwood with pilot hole.
SelectingSpeed
The speed selector is on top of the motor housing.
Allow the tool to come to a complete stop before
changing speeds. See “Applications” for recom-
mended speeds under various conditions.
1. For Low speed (up to 400 RPM), push the speed
selector to display “1”.
2. For High speed (up to 1500 RPM), push the
speed selector to display “2”.
UsingtheControlSwitch
The control switch may be set to three positions:
forward, reverse and lock. Due
to a lockout mechanism, the con-
trol switch can only be adjusted
when the ON/OFF switch is not
pressed. Always allow the mo-
tor to come to a complete stop
before using the control switch.
For forward(clockwise) rota-
tion, push in the control switch
from the right side of the tool.
Checkthedirectionofrotation
beforeuse.
For reverse(counterclockwise)
rotation, push in the control
switch from the left side of the
tool. Checkdirectionofrota-
tionbeforeuse.
Tolock the trigger, push the
control switch to the center po-
sition. The trigger will not work
while the control switch is in the
center locked position. Always
lock the trigger or remove the
battery pack before performing
maintenance, changing acces-
sories, storing the tool and any
time the tool is not in use.
Starting,StoppingandControllingSpeed
1. To start the tool, grasp the handle rmly and pull
the trigger.
NOTE: An LED is turned on when the trigger is
pulled.
2. To vary the speed, increase or decrease the
pressure on the trigger. The further the trigger
is pulled, the greater the speed.
3. To stop the tool, release the trigger. Make sure
the bit comes to a complete stop before laying
the tool down.
BatteryPackProtection
To protect the battery from damage and extend
its life, the tool’s intelligent circuit monitors current
draw, temperature, and voltage drops.
In extremely high torque, binding, stalling, and short
circuit situations that cause high current draw, the
tool will vibrate for about 5 seconds, the fuel gauge
will ash, and then the tool will turn OFF. To reset,
release the trigger.
Under extreme circumstances, the internal tem-
perature of the battery could become too high.
If this happens, the fuel gauge will ash and the
battery pack will shut off. Let the battery pack cool
and then continue work.
This tool provides a quick, convenient means of
drilling small holes and installing and removing
screws. Because of the many screw sizes, types,
thread engagements and materials available, it is
difcult to limit the application of this tool by screw
size. However, for applications in wood, a #6 wood
screw with a full pilot hole is recommended as a
practical limit.
Forward-
Pushfrom
RIGHT
Reverse-
Pushfrom
LEfT
Lock-
Pushto
CENTER
 previous next