Filter
Top Products
3
Ferrite core1
Switch door screw1
Mounting screws (5 x 30 Type 1 tapping screws) 6
Installation panel1
Cord clip 1
Clip mounting screw1
Product
Required items
Pre-installation checks
Checking the installation environment
Do not install in the following types of location.
(This may cause malfunctions.)
Outdoors Locations where the temperature could be lower than 0ºC. Locations where there is a lot of dust
Locations where the temperature could be higher than 40ºC Locations where there is a lot of condensation
Locations where salt damage could occur Vehicles (including ships and airplanes)
Locations where corrosive, neutral, or reductive gases are present
Near food or tableware Kitchens Locations where the appliance may come into direct contact with water
(Where there is a risk of water splashing)
Locations where the appliance is direct sunlight or strong light.
(May cause the sensor to malfunction)
Rooms that have a sterilization basin, swimming pools, bathrooms.
Check the appliance, accessories, and items required for installation
Main unit
Longer than 150mm
Prepare if required
Single wire for internal wiring
(Cable core: between 1.0mm
2
and 2.5mm
2
)
Not needed if the
internal wiring is
c
omplete
Drain tank
Air filter
SCREW ANCHOR6
Use on concrete walls
Wall reinforcement
Reinforces walls made
of materials other than
concrete
Check the heater settings and air speed settings (JTSB216JSH type only)
Check the heater ON/OFF settings and air speed HIGH/STANDARD settings with the customer beforehand.
(The customer cannot adjust the settings after installation is complete.)
Accessories
Pen
To mark position to insert metal
screw plugs in the wall
Screwdriver