Filter
Top Products
PAGE 26 — MQ-WHITEMAN FS1 CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #3 (04/24/03)
FS 1 CONCRETE SAW — INITIAL START-UP
Stopping the Engine
NEVER stop the engine while the blade is in the cut, except
for extreme emergencies. A sudden stoppage of the engine
at high speed while in a cut could damage the blade and/or
saw, and may cause injury to the user or other in the
operating area.
1. Place the throttle lever (Figure 20) in the slow position, and
listen for the engine speed to decrease.
2. Place the engine ON/OFF switch (Figure 18) to the “OFF”
position.
3. Place the fuel valve lever (Figure 17) to the “OFF” position.
Maneuvering The Saw
8. Grasp the starter grip (Figure 21) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
Figure 21. Starter Grip
9. If the engine has started, slowly return the choke lever
(Figure 19) to the
CLOSED
position. If the engine has not
started repeat steps 1 through 5.
10.
Before the saw is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose guard and/or covers.
11. All sawing is done at full throttle. Your engine governor has
been set at the factory to ensure an optimum speed setting.
CAUTION:CAUTION:
CAUTION:CAUTION:
CAUTION:
z
DO NOT pull the starter rope all the way
to the end.
z
DO NOT release the starter rope after
pulling. Allow it to rewind as soon as
possible.
WARNING
The blade is spinning whenever the engine is running.
Raise the blade high above the surface when maneuvering
the saw. Damage to the blade and/or saw may occur if the
blade strike the pavement.
CAUTION:CAUTION:
CAUTION:CAUTION:
CAUTION:
z
NEVER stop the engine in the cut while
working at high speeds, except for
extreme emergencies.