Filter
Top Products
GB2000 BALLOON LIGHT• OPERATION AND PARTS MANUAL — REV. #3 (08/30/12)— PAGE 21
Figure 9. Lamp Removal
ASSEMBLY
1. Remove the 2 screws and 2 nuts that secure the T-Bar
to the mast extension. Discard these items they will not
be used in the reassembly. See Figure 10.
Figure 10. Removing Screws and Nuts
2. Install the lamp mounting bracket (Figure 11) onto the
T-Bar and mast extension with the new screws and
nuts provided.
LAMP
BOLT
NUT
WASHERS
WASHERS
CAUTION
Make sure that the T-bar is supported before removing
the two screws and nuts to prevent T-Bar from falling
off the mast extension.
REMOVE HHC SCREW (2)
1/ 2 -13X3-1/4
P/N 06503-026
REMOVE NYLOC NUT (2)
1/2-13 P/N 10176
T-BAR
MAST
TYPE 1 SETUP (S/N G1900118 AND BELOW)
Figure 11. Installing Bracket
3. Attach junction box (Figure 12) to lamp mounting
bracket with the bolts and washers provided.
Figure 12. Junction Box Installation
INSTALL
SCREWS AND
NUTS (2)
BRACKET
T-BAR
MAST
JUNCTION BOX
CONNECTORS
BRACKET
INSTALL
SCREWS AND
LOCKWASHERS (2)
T-BAR
NOT
SHOWN
MAST