MQ-MIKASA MDR-9D VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #0 (12/17/03) — PAGE 17
MDR-9D — HATZ 1D81Z ENGINE COMPONENTS
Figure 7. HATZ 1D81Z Engine Components
ENGINE COMPONENTS
Figure 7 illustrates the location of the major engine
components of the machine. Each component is described
below:
1. Fuel Filler Cap – Remove this cap to add diesel fuel to the
fuel tank. Make sure cap is tighten securely. DO NOT over
fill.
7. Oil Filler Cap/Dipstick – Remove this cap to add oil to the
oil tank. Use dipstick to check oil level.
8. Oil Drain Plug – Unscrew plug to drain oil from engine
crankcase. Dispose of oil in a safe manner.
9. Decompression Lever – Press down before starting
engine. To prevent damage to the engine, DO NOT use for
any other purpose.
10. Fuel Filter – Controls the flow of diesel fuel to the carburetor.
Must be in the ON position when starting and running the
engine.
11. Oil Filter – filters oil for contaminates. Replace as necessary.
12. Starting Handle Guide Sleeve – Insert starting handle
into the guide sleeve and turn to crank start engine.
DANGER
Adding fuel to the tank should be done only when
the engine is stopped and has had an opportunity
to cool down. In the event of a fuel spill, DO NOT attempt to start the
engine until the fuel residue has been completely wiped up, and the
area surrounding the engine is dry.
2. Fuel Tank – Diesel engine holds 5.8 quarts of diesel fuel.
3. Air Cleaner – Prevents dirt and other debris from entering
the fuel system. Remove wing-nut on top of air filter
cannister to gain access to filter element.
Operating the engine without
an air filter, with a damaged air
filter, or a filter in need of
replacement will allow dirt to
enter the engine, causing rapid
engine wear.
NOTE
WARNING
Engine components can generate extreme heat.
To prevent burns, DO NOT touch these areas
while the engine is running or immediately after operating. NEVER
operate the engine with the muffler removed.
4. Muffler – Used to reduce noise and emissions.