Filter
Top Products
MQ-MIKASA MDR-9D VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #0 (12/17/03) — PAGE 29
MDR-9D — MAINTENANCE
NEUTRAL POSITION ADJUSTMENT
Once the travel lever has veen set to neutral position with the
engine running, the hydraulic brake is is operating and the roller
should not move. If the roller inches forward or backwards with
the lever in the neutral position, turn-buckle of the cable should
be adjusted as follows:
1. Stop the engine and set the travel lever in the neutral
position.
2. Unscrew the two lock nuts on the sides of the cable (Figures
38 and 39).
3. If the machine moves forward, screw the turn-buckle
clockwise. If the machine moves backwards, screw the turn-
buckle counterclockwise (Figure 40).
4. Screw back the lock nuts on the turn-buckle.
5. Start the engine and make sure that the roller does not inch
forward or backward at the neutral position of the travel
lever.
Figure 38. Unscrewing Right Lock Nut
Figure 39. Unscrewing Left Lock Nut
Figure 40. Adjusting the Turn-Buckle
If the neutral position of the travel lever and the neutral point of
transmission do not match after adjusment is repeated, align as
follows:
1. Loosen the hex socket head bolt used for mounting the
control lever on the underside of the transmission (Figure
41).
2. For forward movement, move the control lever slightly to the
left.
3. for backwards movement, move the control lever slighty to
the right.
Figure 41. Unscrewing Left Lock Nut