Filter
Top Products
PAGE 20 — MP1 — OPERATION AND PARTS MANUAL — REV. #3 (03/29/10)
Whenever cleaning, adjusting or lubricating any part of the saw,
MAKE CERTAIN to place the power ON/OFF switch in the OFF
position and disconnect the plug from the power source.
PRE-SETUP (ELECTRIC)
Assembly (Electric Powered Saws Only)
1. Open the shipping container carefully, lift the saw by its carrying
handles and place it on a suitable table or platform. Make sure
the table or platform can support the weight of the saw. The
saw platform should be rigid and stationary so that it will not
move, sag, or sway due to the vibrations and movements of
the saw.
2. If using the MP1 series
support stand kit
(P/N TRAK14SS),
attach stand to the under-side of the water tray. Follow the
instructions supplied with the support stand kit when attaching
it to the water tray.
3. Attach the clear plastic water hose (Figure 5) coming from the
blade guard to the water pump.
4. Fill the water tray with
clean fresh water
. The
water
pump
intake must always be fully covered by water
. Also,
keep the pump intake free of sludge, debris and other
materials that may accumulate in the tray.
5. Make certain that the water hose will not come in contact
with the blade or interfere with any moving parts. The best
location for the water pump/strainer is between the splash
shield and the rear of the water tray. This will prevent some
of the abrasive particles from flowing through the pump.
6. Insert the water pump
power plug
into the outlet receptacle
on the electric motor conduit box as shown in Figure 6.
CONVEYOR CART PLACEMENT
1. Place the conveyor cart across the water tray as shown in
Figure 7. Align the wheels of the cart with the outer edge of the
water tray. Push the cart back and forth, it should move freely in
both directions.
Figure 5. Water Tray/Water Pump
Figure 6. Water Pump Power Connection
Figure 7. Conveyor Cart Placement
PRE-SETUP
WARNING