Filter
Top Products
PAGE 20 — MVH-200GH PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #2 (09/22/06)
Lifting:
1. Use a crane or lift to load and unload the machine. A skilled
crane operator is required to perform the job.
2. When lifting the machine, check for any damaged or loose
bolts, lifting hooks, and shock mounts.
3. Check any damaged or loose bolts in the guard frame to
avoid machine sliding off.
4. Make sure that the machine is shut off before machine is
lifted.
5. Use reliable cable for lifting.
6. Always lift the machine vertically and keep the machine away
from workers and animals.
7. Do not lift the machine higher than the required height.
MVH-200GH — OPERATION
Stowing the Handle:
1. Push up the handle (Figure 20).
2. Pull the stopper grip upward into the hole of the guard frame
to lock the handle.
Figure 20 . Stowing the Handle
Adjusting Handle Height:
The height of the handle is adjustable for your comfort .
1. Loosen the butterfly screw (Figure 19).
2. Turn the grip clockwise to raise the handle or counterclockwise
to lower the handle.
3. When the handle is raised to the desired height, tighten the
butterfly screw.
Figure 19. Handle Adjustment
Transporting:
1. Always make sure that the machine is shut off while being
transported.
2. Check that the fuel cap is properly closed and tightened.
3. When traveling long distances or on rugged terrain, drain the
fuel of the machine before transporting.
4. Tie down the machine securely on the transportation so that
it will not move or topple over.