Filter
Top Products
MVH-200GH PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #2 (09/22/06) — PAGE 21
MVH-200GH — MAINTENANCE
Inspection and Maintenance Service Tables.
To make sure your plate compactor is always in good working
condition before using, carry out the maintenance inspection in
accordance with Tables 5 through 7.
Daily Service
z
Check for leakage of fuel or oil.
z
Check for loose screws including tightness. See Table 6
below (tightening torque ), for retightening:
z
Remove soil and clean the bottom of compaction plate.
z
Check hydraulic pump, piping and hose for any leakage. A
loosened hydraulic hose can be a cause for leakage. Check
hydraulic hose connections with wrench applied for
tightness.
z
Check engine oil.
.7ELBAT
retemaiD)mc/gk.ni(EUQROTGNINETHGIT
lairetaM
mm6 mm8 mm01 mm21 mm41 mm61 mm81 mm02
T4 07 051 003 005 057 001,1 004,1 000,2
T8-6 001 052 005 008 003,1 000,2 007,2 008,3
T11 051 004 008 002,1 000,2 009,2 002,4 006,5
* 001
~003
053
~056
007
)munimulafositrap-retnuocesacnI(*
)dednahthgirllaeraenihcamsihthtiwesunisdaerhT(
.wercsdna,tlobhcaenode
kramsilairetamfoytilauqdnalairetaM
HG002-HVM.5ELBATNOITCEPSNIENIHCAM
METI
FOSRUOH
NOITAREPO
SKRAMER
gnissiMroesooL
swercS
sruoh8yrevE
)yadyreve(
straPdegamaD
sruoh8yrevE
)yadyreve(
gnillortnoCfonoitcnuF
traPmetsyS
sruoh8yrevE
)yadyreve(
kaeLmetsySciluardyHsruoh001yrevE
kcehCliOrotarbiVsru
oh001yrevE32egapeeS
liOrotarbiV
tnemecalpeR
sruoh003yrevE32egapeeS
kcehCliOciluardyHsruoh001yrevE32egapeeS
liO
ciluardyH
tnemecalpeR
002retfatsriF
yreveneht,sruoh
sruoh000,1
42egapeeS
kcehC)hctulc(tleb-Vsruoh002yrevE32eg
apeeS
kcehCyrettaBsruoh001yrevE52egapeeS
HG002-HVM.6ELBATKCEHCENIGNE
METINOITAREPOFOSRUOH
kcehCgulPkrapS)keewyreve(sruoh04yrevE
kaeLleuFroliO)yadyreve(sruoh8yrevE
gninetsaFfoss
enthgiT
sdaerhT
)yadyreve(sruoh8yrevE
dnakcehCliOenignE
tnemhsinelpeR
)yadyreve(sruoh8yrevE
mumixamdeificep
sothsinelpeR(
)level
tnemecalpeRliOenignE
ot05yrevenehtsruoh52tsrifretfA
sruoh001
gninaelCretliFriAsruoh001
yrevE
.kcehcenignenosliatedroflaunamenigneetarapeseeS
These inspection intervals are for
operation under normal conditions.
Adjust your inspection intervals
based on the number hours plate
compactor is in use, and particular
working conditions. Fuel piping and
connections should be replaced
every 2 years.
Inspection and other services should
always
be carried out
on hard and level ground with the engine shutdown.
CAUTION - General Maintenance Safety
NOTE