Filter
Top Products
R2000H RIDE-ON STATIC ROLLER — OPERATION & PARTS MANUAL — REV. #4 (07/24/08) — PAGE 25
Water Sprinklers Control
1. If the application requires the wetting of a surface, open
the
water valve
located at the bottom of the roller floor
(Figure 16) to spread the proper amount of water onto the
roller drum at the desired rate that will wet both the front
and rear rollers.
Figure 16. Water Sprinkler Valve (ON)
Normal Shut-Down
1. Place the engine throttle lever in the idle position. Let the
engine idle for 3-5 minutes.
2. If the water valve is open, close it (Figure17)
Figure 17. Water Sprinkler Valve (OFF)
R2000H — OPERATION
3.
Place
the transmission lever (Figure 18) in the
neutral
position
.
Figure 18. Transmission Control Lever (Neutral)
4.
Place
the parking brake lever (Figure 19) in the
set position
.
This will lock the rear roller drum in place, and prevent the
roller from moving. Whenever the operator's seat is vacated,
place the transmission lever in neutral, and set the parking
brake
5. Turn the ignition key (Figure X) to the OFF position remove
key. Store key in a safe place.
Figure 20. Ignition Switch (OFF)
Figure 19. Parking Brake Lever (Set)
6. Place the engine
fuel valve lever
(Figure 20) in the OFF
position.
7. To prevent the roller from moving, place chock blocks under
each roller drum
8. Clean the entire roller with warm water and mild soap. Pay
close attention to the scrapper bar and spray bar holes,
making sure that no dirt or debris is present. Dirt and debris
can cause the sprinkler system to get clogged.
Emergency Shut-Down
1. Turn the ignition key (Figure20) to the OFF position.
2. Place the engine
fuel valve lever
(Figure 11) in the OFF
position.