Filter
Top Products
8
W415-0689 / 06.25.08
2
MOUNTING
BRACKET
4
3
KEYHOLE
INSTALLATION
TEMPLATE
TORCH
MOUNTING
FRAME
CABINET
1
NOTE: It is recommended that all fasteners be
stainless steel.
1. Using the installation template (W122-0401) supplied,
determine the best mounting location for your new Torch.
(refer to your manual for clearances) Mark all 14 hole
centres on the wall (surface) using the template.
2. Remove the template. Depending on the surface and
fasteners, drill the appropriate holes. Hold the Torch up,
aligning the mounting brackets to the mounting holes.
Secure the Torch to the wall using the appropriate
fasteners. NOTE: The Torch has been designed to
have a 1/2” clearance between the rear outer panel
and the mounting surface.
3. Start the fasteners into each of the six remaining
mounting holes. Align the keyholes of the frame to the
heads of the fasteners and slide the frame down onto the
fasteners. Ensure the frame is plumb and level before
tightening the fasteners. NOTE: It is recommended that
the gas and electrical be connected to the appliance
at this stage. Both must enter the appliance at the
opening created between the bottom of the Torch
and the bottom of the mounting frame.
4. Slide the front of the cabinet over the mounting
frame, ensuring the “mesh” is to the top. Start each of
the four screws (supplied) through the slots. Once the
cabinet has been adjusted for depth the
four screws can be tightened.
TMCSS MOUNTING CABINET INSTALLATION
FINISHING
FIGURE 6
!
WARNING
Before starting the installation remove the
protective layer from all three components that
make up the GSST8 (cabinet, frame, and Torch)