Napoleon Fireplaces GSST8P Blowtorch User Manual


 
9
W415-0689 / 06.25.08
RAIN TABS
DOOR REMOVAL
GLASS REMOVAL
Having removed the door, lay on a smooth at surface, face down.
There are 4 glass retainers that need to be bent away from the
glass to release it from the frame. Do not pry on the glass.
When replacing DO NOT SUBSTITUTE MATERIAL, replace the
gasket (W562-0008) and the glass (W300-0110). Set new glass
into the frame and gently bend tabs into the gasket to secure.
* Ensure that the gasketed end of the glass is placed into the top of
the door frame.
NOTE: Care must be taken when removing and disposing of any
broken glass or damaged components. Be sure to vacuum up
any broken glass from inside the appliance before operation.
FIGURE 9
GLASS
RETAINERS
GASKET*
GLASS
TOP
FIGURE 11
B
O
T
T
O
M
D
O
O
R
R
E
T
A
I
N
E
R
T
O
P
D
O
O
R
F
L
A
N
G
E
SECURING THE DOOR IN PLACE
When shipped, the door is secured with two hitch pins
along the top edge, replacing them is optional.
To secure the door in place use the supplied hitch pins as
illustrated.
90º
6
RAIN
TAB
When shipped, the rain tabs should be at a 90º angle. Push
the rain tabs down until they are at an approximate 60º angle to
assist rain in running off and out of the unit.
HITCH PIN
The door is held in place at the bottom by a retainer tab
that inserts into a slot in the bottom edge of the door, and
at the top with a tab that secures in the same fashion. The
door is removed by lifting it off the tabs. When replacing,
guide the door over the upper tab rst, then over the lower
tab.
FIGURE 8
FIGURE 10