Filter
Top Products
TOOL USE AND CARE
• Do not force the power tool. Use the correct power tool for your application.
The
correct power tool will do the job better and safer at the rate for which it was designed.
• Do not use the power tool if the switch does not turn it on and off. Any power tool
that cannot be controlled with the switch is dangerous and must be repaired by an
authorized service representative.
• Disconnect the power from tool and place the switch in the locked or off position
before making any adjustments, changing accessories, or storing power tools. Make
sure blade has stopped. Such preventive safety measures reduce the risk of starting the
power tool accidentally.
• Secure work with clamps or a vise instead of your hand to hold work when practical.
This safety precaution allows for proper tool operation using both hands.
• Store idle power tools out of the reach of children and do not allow persons
unfamiliar with the power tool or these instructions to operate the power tool. Power
tools are dangerous in the hands of untrained users.
• Maintain power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tools operation. If
damaged, have the power tool repaired before use.
Many accidents are caused by
poorly maintained power tools.
• Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may create a risk of injury when used on
another tool.
• Keep guards in place and in working order.
• Never leave tool running unattended.
• Before drilling into walls, ceilings etc, ensure there are no concealed power cables or
pipes in the cavity.
• Always use the side handle; this gives you greater control if the accessory should
become jammed.
• Keep the cord clear of the accessory being used. Do not wrap the cord around your
arm or wrist.
• Get a good grip. Hold the tool by the insulated gripping surfaces when performing an
operation where the accessory may contact hidden wiring or its own cord.
• Use thick cushioned gloves and limit the exposure time by taking frequent breaks.
Vibration caused by the hammer action may be harmful to your hands and arms.
• When removing an accessory from the tool, avoid contact with skin and use proper
protective gloves when grasping the bit or accessory. Accessories may be hot after
prolonged use.
• Always wear eye protection and a dust mask, especially for dusty applications and
when drilling / chiseling overhead. Sanding particles can be absorbed by your eyes and
inhaled easily and may cause health complications.
WARNING! The use of any accessory or attachment, or performance of any operation
with this tool other than those recommended in this instruction manual may present a risk of
personal injury.
3