Filter
Top Products
Fitting and changing tools (Fig.2)
The device is equipped with a SDS-plus attachment system.
• clean tools and grease with a thin layer of machine grease before fitting.
• Pull back fastening sleeve (A, Fig.2) and hold.
• Push and rotate the dust-free tool into the tool holder as far as it will go. The tool will
lock automatically.
• Check that it has locked by pulling the tool.
Removing SDS-plus tool (Fig.3)
Pull back fastening sleeve (A), hold and remove the tool.
Starting work (Fig.1)
Switching ON/OFF
• switching on: Press the operating switch (3).
• switching off: Press the operating switch (3) briefly and let go.
5