Filter
Top Products
10- ENG
A10260
Assemble Rubber Feet
1. Attach rubber feet with the screws,
washers, and nuts provided as shown.
2. Tighten securely.
To Assemble Wheels
It will be necessary to brace
or support one side of the
unit when installing the wheels because the
compressor will have a tendency to tip.
1. Attach wheels with shoulder bolts and nuts
as shown.
2. Tighten securely.
NOTE: The unit will sit
level if the wheels are properly installed.
The wheels and handle
do not provide adequate
clearance, stability or support for pulling the
unit up and down stairs or steps. The unit
must be lifted, or pushed up a ramp.
Wheel
Shoulder Bolt
Nut
6. If the handle has excessive movement, it is improperly installed. Check the
following.
A. Are both tabs inside the handle (Step #3)?
B. Does each clip pass through both the saddle and handle (Step #4)?
Screw
Nut
Flat
Washer
Rubber Foot