Filter
Top Products
11- ENG
A10260
To Add Oil To Pump
Compressors are shipped without oil. A small amount
of oil may be present in the pump upon receipt of the air
compressor. This is due to plant testing and does not mean the pump
contains oil. Do not attempt to operate this air compressor without first
adding oil to the crankcase. Serious damage can result from even limited
operation unless filled with oil and broken in correctly. Make sure to
closely follow initial start-up procedures.
Multi-Viscosity motor oils, like 10W30, should not be
used in an air compressor. They leave carbon deposits on
critical components, thus reducing performance and compressor life. Use
air compressor oil only.
NOTE: Oil is included with some units. If oil is not included, use an oil
specifically formulated for use in an air compressor, such as Porter-Cable PAS1
air compressor oil. Oil may be found at the store where the air compressor was
purchased.
1. Place unit on a level surface.
Risk from Flying Object. Drain tank to release air pressure
before removing the dipstick. See "To Drain Tank" in the
"Maintenance" section.
2. Remove oil fill plug (A) and slowly add
a compressor oil until it is even with the
top of the oil fill hole.
NOTE: Do not
allow oil to be lower than 3/8" (6 threads)
from the top at any time. When filling
the crankcase, the oil flows very slowly
into the pump. If the oil is added too
quickly, it will overflow and appear to
be full.
NOTE: Crankcase oil capacity is
approximately 16 fluid ounces.
3. Replace oil fill plug.
A