Filter
Top Products
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web Support: www.omegawolf.com/powercraft
Model Number:
PBF-1200 09
Safety instructions
5) Servicing
(a) Have your machine repaired by qualified expert staff using original
spare parts only.
(b) Caution! The use of accessories or add-on devices other than those
recommended in these instructions may mean a risk of injury. Use
original spare parts only.
Additional safety instr
uctions
• Please check workpieces for any obstructions on the surface of the material,
such as protruding nails etc., to protect the router head.
• Wait until the router has come to a complete stop before removing any bloc-
ked or routed material around the cutter. Use a long stick for this and not your
finger.
• Please keep your hands away from the routing surface.
• Immediately switch off the tool if it starts producing any unusual noise or
starts vibrating excessively.
Always check that the power supply corresponds to the voltage on the
rating plate.
Your machine is double insulated, therefore no earthwire is required.
• Immediately throw away old cables or plugs when they have been replaced by
new ones. It is dangerous to insert the plug of a loose cable in the wall outlet.
• Only use an approved extension cable suitable for the power input of the machi-
ne. The minimum conductor size is 1.5 mm
2
. When using a cable reel always un-
wind the reel completely.
Prior to mounting an accessory always unplug the tool.
Wait until the machine has come to a complete standstill and the cut-
ter has cooled down before replacing a cutter.
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web Support: www.omegawolf.com/powercraft
Model Number:
PBF-1200 12
Assembly
Mounting the adapter for dust extraction
Fig. E Fig. F
Use the dust adapter for the extraction of dust.
• Mount the dust adapter (24, Fig. E) with the screws (22) on the cutter sole (3).
• Place the dust tube (25) in the dust output (16 Fig. F).
• Place the tube of your vacuum cleaner on the dust tube (25, Fig. F).
Keep the outlet of the machine behind the machine for a good view
on the workpiece.
16
25
22
24
22
3