Panasonic EY6450 Drill User Manual


 
-
6
-
-
7
-
.ASSEMBLY
Attaching or removing bit
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center posi-
tion (switch lock).
This tool is equipped with a keyless
drill chuck.
1. Attachment
Insert the bit and turn the lock collar
clockwise (looking from the front) to
tighten firmly until it stops clicking.
Lock collar
2. Removal
Turn the lock collar counterclockwise
(looking from the front), then remove
the bit.
3. Storage
Keep the bit in bit holder when not in
use.
Remove the battery pack to expose
the bit storage compartment inside
the handle housing.
Bits up to 50 mm
(1-31/32 inch)
long can be stored
here.
NOTE:
If excessive play occurs in the chuck,
secure the drill in place and open
the chuck jaws by turning the lock
collar and tighten the screw (left-
handed screw) with a screwdriver by
turning it counterclockwise (viewed
from the front).
Attaching or removing
battery pack
1. To connect the battery pack:
Insert the battery pack. It snaps into
place to indicate proper connection.
2. To remove the battery pack:
Press the two buttons on the sides
of the battery pack. Slide the battery
pack out of the tool body.
Support handle
Place the support handle at your
favorite position and tighten the han-
dle securely.
Loosen Tighten
Remove the handle when placing the
tool in the storage case.
.OPERATION
Switch Operation
1. The speed increases with the amount
of depression of the trigger. When
beginning work, depress the trigger
slightly to start the rotation slowly.
2. A feedback electronic controller is
used to give a strong torque even in
low speed.
3. The brake operates when the trigger
is released and the motor stops imme-
diately.
NOTE:
When the brake operates, a braking
sound may be heard. This is normal.
Forward / Reverse lever
Operation
(Forward ( ), Switch lock, Reverse ( ))