Filter
Top Products
Follow steps 1 to 5 in section ‘Middle dial’ in this chapter.
You can choose one of the following sounds:
- Radio (Fig. 12)
- Birds (Fig. 13)
- Beep (Fig. 14)
- African jungle (Fig. 15)
- Wind chimes (Fig. 16)
1 Push down the control lever to the bottom position when the
alarm goes off. (Fig. 17)
, The lamp continues to be on at the selected intensity level, but the
alarm sound stops. After 9 minutes, the wake-up sound is
automatically played again.
Note: The 9-minute snooze time is xed. This time cannot be adjusted.
Note: If you push down the control lever with too much force, it may jump
back to off position.
If you want to get a quick demonstration (60 seconds) of the gradually
increasing light level and sound level, activate the test function of the
appliance.
1 Push the control lever down to the bottom position for a few
seconds until TEST appears on the display (Fig. 18).
2 Push the control lever down again to stop the demonstration.
Note: The appliance continues to run the alarm demonstration until you
push down the control lever again. The test automatically stops after 9 hours.
You can use the top dial to switch on the lamp as a bedside lamp and to
set the light intensity.
1 To switch on the lamp, press the top dial gently and release
it. (Fig. 19)
13