Filter
Top Products
Note: It takes approx. 1 second for the lamp to go on. This is normal, the
lamp needs to heat up.
Note: The lamp does not go on when you press the top dial while the
appliance is in the menu.
2 Move the top dial up or down to select the light intensity level you
prefer. (Fig. 20)
You can choose a light intensity between 1 and 20.
Note: The light intensity you have selected is automatically set as the light
intensity level for the alarm as well.
3 To switch off the lamp, press the top dial gently and release it.
Note: You can also move the top dial up or down to check and/or select a
light intensity level without pressing the top dial rst.
1 To switch on the radio, press the bottom dial gently and release
it. (Fig. 21)
2 To select the desired radio frequency manually, move the middle
dial up or down (Fig. 22).
Tip: To scan radio frequencies automatically, press and hold the middle dial
for approx. 2 seconds.
Tip: To make sure you get a good radio signal, fully unwind the antenna and
move it around until you have found a position at which reception is best.
3 To switch off the radio, press the bottom dial gently and release it.
1 To set the volume, move the bottom dial up or down to select
the volume level you prefer.
You can choose a volume level between 1 and 20.
Note: The volume level you select is automatically set as the volume level for
the alarm as well.
14