Polycom 5040 Battery Charger User Manual


 
Polycom, Inc. 11
Polycom Kirk 5020-5040 User Guide Getting Started
á Place handset in charger.
For correct charging, be sure the room temperature is between 0°C/32°F and
40°C/104°F. Do not place the handset in direct sunlight. The battery has a
built-in heat sensor which will stop charging if the battery temperature is too
high.
If the handset is turned off when placed in charger, nothing indicates the
charging. There will be no reaction on incoming calls.
If the handset is turned on when charging, the display shows the blue charging
icon in the status bar. The charging icon is replaced by the green fully
charged icon , when the battery is fully charged (when handset is removed
from charger, the charging icon disappears). The handset will not vibrate. Auto
answer is inactive. The handset reacts normally for incoming calls.
It is necessary to recharge battery when display shows the battery low icon ,
or if the handset cannot be turned on.
Battery Capacity
The capacity of the battery depends on the use of backlight and talk time.
Battery capacity in active mode:
5020: up to 20 hours of talk time. 5040: up to 15 hours of talk time.
Battery capacity in standby mode:
5020: 200 hours when display backlight is turned off. 5040: 100 hours when
display backlight is turned off.
5020: 100 hours when display backlight is set at dimmed. 5040: 60 hours
when display backlight is set at dimmed.
For information about how to check battery capacity, refer to “Battery” on page
53.