Filter
Top Products
14
Fig. 22B
A
WATER PUMP
The flow rate dial (A) Fig. 22B, should
be set on the maximum setting.
RIP GUIDE
The rip guide (A) Fig. 22A is used to
make precision cuts. Loosen knob (B),
position the rip guide on the cutting
tray scale to the amount of tile to be
cut off and then tighten knob. Hold
the tile against the rip guide and the
cutting tray and proceed to cut the tile
as discussed in the section
“OPERATING TILE SAW.”
Fig. 23
A
KEEP TOOL CLEAN
Periodically blow out all air
passages with dry compressed air.
All plastic parts should be cleaned
with a soft damp cloth. NEVER use
solvents to clean plastic parts. They
could possibly dissolve or otherwise
damage the material.
Wear ANSI Z87.1
safety glasses while using
compressed air.
The cutting tray can be detached
for cleaning purposes by pulling the
locking pin (A) Fig. 23 out, so that
the tray can slide off the rail.
Change water in water tray daily.
Do not leave water in water tray
overnight.
Do not cut tile
without using the tile cutting tray.
MAINTENANCE
FAILURE TO START
Should your tool fail to start, check
to make sure the prongs on the
cord plug are making good contact
in the outlet. Also, check for blown
fuses or open circuit breakers in the
line.