Filter
Top Products
8
TO START AND STOP TOOL
1. Make certain the switch is in the “OFF” position, and the
power source is the same as that specified on the tool’s nameplate.
2. Connect the tool to the power source.
3. Slide the switch button (A), Fig. 2, forward to start motor. Slide switch
button to the rear to stop motor.
VARIABLE SPEED MODELS
Speed is adjusted by turning
thumbwheel (A), Fig. 2A. Thumb-
wheel position #1 provides the
slowest operating speed (2500 OPM)
and position #6 the fastest (6000
OPM). Speed may be changed while
motor is running or while it is
stopped.
USING THE POLISHER
If the item to be polished is light enough to be moved
by the rotating pad, it should be securely anchored to prevent
possible bodily injury
1. Read and follow directions supplied with the product (polishes, waxes,
cleaners, etc.) being used.
2. Apply a small amount of product directly to the polishing pad.
3. Grasp polisher firmly with both hands, one hand on auxiliary handle and
one hand on motor housing (see Fig. 3).
4. Position polisher with polishing pad against work surface and then start
the polisher. NEVER run the polisher while the pad is not in contact with the
work surface: always start and stop polisher while the pad is in contact with
the work surface.
5. Move polisher back and forth in a sweeping motion, overlapping each
pass with the previous.