Filter
Top Products
4
2. Wear ear protectors when using the tool for extended periods.
Prolonged exposure to high intensity noise can cause hearing loss.
3. There are certain applications for which this tool was designed.
Porter-Cable strongly recommends that this tool NOT be modified and/or
used for any application other than for which it was designed. If you have any
questions relative to its application DO NOT use the tool until you have
written Porter-Cable and we have advised you.
Technical Service Manager
Porter-Cable Corporation
4825 Highway 45 North
Jackson, TN 38305
SYMBOL DEFINITION
V .......................... volts
A .......................... amperes
Hz .......................... hertz
W .......................... watts
kW .......................... kilowatts
µF .......................... microfarads
l .......................... liters
kg .......................... kilograms
N/cm
2
.......................... newtons per square centimeter
Pa .......................... pascals
h .......................... hours
min .......................... minutes
s .......................... seconds
.......................... alternating current
3 .......................... three-phase alternating current
3
N .......................... three-phase alternating current with neutral
.......................... direct current
n
0
.......................... no load
.......................... alternating or direct current
.......................... Class II Construction
.......................... splash-proof construction
.......................... watertight construction
…/min .......................... revolutions or reciprocation per minute
REPLACEMENT PARTS
When servicing use only identical replacement parts.
MOTOR
Many Porter-Cable tools will operate on either D.C., or single phase 25 to 60
cycle A.C. current and voltage within plus or minus 5 percent of that shown
on the specification plate on the tool. Several models, however, are designed
for A.C. current only. Refer to the specification plate on your tool for proper
voltage and current rating.
______
– – – –