Filter
Top Products
10
IMPORTANT: A trigger, which will limit the tool to “single sequential
actuation” only, is available free-of-charge by calling 1-800-321-9443 in the
United States and Canada or 001-731-660-9374 outside the United States
and Canada, and providing tool model number, type, serial number, etc. For
identification purposes: the single sequential actuation trigger is red.
Disconnect tool from air supply before performing
maintenance, clearing a jammed fastener, leaving work
area, moving tool to another location, or handing the tool
to another person.
Clean and inspect tool daily. Carefully check for proper
operation of trigger and safety mechanism. Do Not use the tool unless
both the trigger and the safety mechanism are functional, or if the tool is
leaking air or needs any other repair.
The depth to which a fastener is driven is controlled by the depth adjustment
knob (A) Fig. 25. The depth of drive is factory adjusted to a nominal setting.
Test fire a fastener and check
depth. If a change is desired, rotate
the adjustment knob (A) Fig. 25. The
adjustment knob has detents every
1
/4 turn. Rotate the knob (A) Fig. 25
counterclockwise to increase the
depth of drive, rotate the knob
clockwise to decrease the depth of
drive. Test fire another fastener and
check depth. Repeat as necessary
to achieve desired results. The
amount of air pressure required will
vary depending on the size of the fastener and
the material being fastened. Experiment with
the air pressure setting to determine the lowest
setting that will consistently perform the job at
hand (Fig. 25B). Air pressure in excess of that
required can cause premature wear and/or
damage to the tool.
A rubber nose cushion (A) Fig. 26 is provided to reduce marring of the work
surface. The rubber cushion can be removed, and stored inside knob (B) Fig.
27, to provide increased depth-of-drive for toe-nailing applications.
Disconnect tool from air supply before removing or
reinstalling rubber cushion.
Fig. 27
A
Fig. 25
A
B
Fig. 26
Fig. 25B
Nail Size Pressure
.113 x 2" 80
.113 x 2-
3
/8
" 90
.120 x 3" 110
.131 x 3" 110
.148 x 3" 130
.120 x 3-
1
/4" 130
.131 x 3-
1
/4" 130
.131 x 3-
1
/2" 150