Filter
Top Products
7
Employer must enforce compliance with the safety warnings and all other
instructions contained in this manual.
Keep this manual available for use by all people assigned to use this tool.
For personal safety and proper operation of this tool, read and understand
tool labels and manual. Failure to follow warnings could result in DEATH or
SERIOUS INJURY. Read and follow all of these instructions carefully.
Porter-Cable HP FRAMER
HHIIGGHH PPRREESSSSUURREE
®
Model FRP350 is a high
pressure heavy duty pneumatic framing nailer. It is designed to install 22
degree round head, plastic collated framing nails .113" - .148" dia. of various
lengths from 2" to 3
1
/2".
Use approved Porter-Cable fasteners only.
1) HP FRAMER
HHIIGGHH PPRREESSSSUURREE
®
3) Air Tool Oil Bottle
2) 3/8" NPT plug with cap 4) Instruction Manual
POWER SOURCE
This tool is designed to operate on clean, dry, compressed air at regulated
pressures between 80 and 150 PSI (Pounds per Square Inch)
(5.5 to 10.3
BAR)
. The preferred system would include a filter, a pressure regulator, and an
automatic oiler located as close to the tool as possible, within 15 ft/4.6 m is
ideal.
The tool is equipped with a
3
/
8" male quick connector.
All compressed air contains moisture and other contaminates that are
detrimental to internal components of the tool. An air line filter will remove
most of these contaminates and significantly prolong the life of the tool. If an
in-line oiler is not available: place five or six drops of Air Tool Oil into the
tool’s air inlet at the beginning of each workday.
1. After reading and understanding this entire manual, connect tool to
air supply (Fig. 18).
2. Orient a strip of approved fasteners with points down (A) Fig. 19, align,
and insert into the magazine “T” slot. Points first.
Do not load fastener strip into magazine backwards.
3. Observe fastener icon (A) Fig. 20. Insert fasteners (B) Fig. 20 with points
down (C) Fig. 20. Slide fasteners forward to the front of the magazine. The
magazine will hold two full strips of fasteners.
IMPORTANT: Fasteners must point in the same direction as they will be
driven.
NOTE: This tool has a mechanical lock out device which restricts the
tool from firing when the quantity of nails in the magazine is reduced to
four. When attempting to unload the magazine be certain to remove all
four nails from the magazine, otherwise one loose nail could jam in the
magazine when the tool is reloaded and fired.
EMPLOYER’S RESPONSIBILITIES
FUNCTIONAL DESCRIPTION
CARTON CONTENTS
PREPARING THE TOOL
NOTE: This tool is shipped completely assembled. No assembly time or
tools are required.