Filter
Top Products
7
Unpacking
Remove all contents from the shipping carton
and check against the Contents of Shipping
Carton below to verify that all items have been
received.
Report any damage to your distributor.
Do not discard any shipping material until after
the dust collector has been assembled and is
running properly.
You will also require either the Filter Bag System
or Canister Filter System. These items are
packaged separately and are not listed here.
Contents of Shipping Carton
Refer to Figure 3 to identify items H–W.
H Base (1)
J Casters (4)
K Motor/Fan Assembly (1)
L Inlet Guard (1)
M Inlet Port w/ Cap (1)
N Lower Gasket (1)
O Connector Tube (1)
P Control Box (1)
R Upper Gasket (1)
S Collector Housing (1)
T Support Bar (1)
U Handle (2)
V Plate (2)
W Socket Head Cap Screw, M8x12 (4)
-- Remote Control w/ batteries (not shown) (1)
-- Owner's Manual (not shown) (1)
-- Warranty Card (not shown) (1)
Main Hardware Bag contents (Figure 1):
A – M8 x 20 Hex Cap Screws (24)*
B – M6 x 12 Pan Head Flange Screws (8)*
C – M8 Flat Washers (34)*
D – M10 Flat Washers (6)*
E – M8 Hex Nuts (16)*
F – 3/8" Hex Nuts (4) – on casters
G – M10 Lock Washers (4) – on casters
Cone Assembly and Hardware (Figure 2):
AA – Support Bracket (1)
BB – Cone (1)
CC – M8 x 16 Hex Cap Screw (1)
DD – M8 Flat Washer (1)
EE – M8 Hex Nut (1)
FF – M 6 x 12 Hex Cap Screws (4)
GG – M6 Hex Nuts (4)
Figure 1: Main Hardware Bag contents
* A through E comprise PM1300-BMHP
Base Machine Hardware Package
Figure 2: Cone Assembly and Hardware
CC through GG comprise DC1100-HP2
Cone Assembly Hardware Package
Tools Required for Assembly
– 13mm Wrenches or Sockets
– 14mm Wrench
#2 Cross Point Screw Driver
6mm hex (“Allen”) wrench