Filter
Top Products
7
Shipping Contents
Unpacking
Remove box and wood crating completely from
around saw. Check for shipping damage. Report
any damage immediately to your distributor and
shipping agent. Do not discard any shipping
material until the Table Saw is assembled and
running properly.
Compare the contents of your container with the
parts lists on this page and the following page to
make sure all parts are intact. Missing parts, if
any, should be reported to your distributor. Read
the instruction manual thoroughly for assembly,
maintenance and safety instructions.
1. Unbolt the saw from the skid.
2. Carefully remove the saw from the pallet
and place it in position.
IMPORTANT: The saw is extremely heavy.
It is strongly recommended that a sling or
hoist system be used to remove the saw
from the pallet.
The Table Saw should be placed in an area with
a sturdy, level floor, good ventilation and
sufficient lighting. Leave enough space around
the machine for mounting extension wings and
rail assemblies, and loading and off-loading
stock and general maintenance work.
Cleaning
Exposed metal surfaces, such as the table top
and extension wings, have been given a
protective coating at the factory. This should be
removed with a soft cloth moistened with
kerosene. Do not use acetone, gasoline, or
lacquer thinner for this purpose. Do not use
solvents on plastic parts, and do not use an
abrasive pad because it may scratch the
surfaces.
Contents of the Shipping Container
Main Saw Container
1 Table Saw (A)
1 Table Insert (B)
1 Small Box (shown page 8)
The following items are inside the saw:
1 Miter Gauge Assembly (C)
1 Blade Guard Assembly (D)
1 Switch in box (E)
1 Owner's Manual (not shown)
1 Warranty Card (not shown)