Filter
Top Products
10
6. If it is necessary to cut a tenon on the side of
the workpiece that is against the fence, a
wood spacer must be secured between the
workpiece and the fence, as shown in Figure
9. This will keep the saw blade from hitting
the fence.
Note: There are four holes in the fence for
mounting a wood block spacer.
Angle Tenons
For angle tenons, loosen lock lever (F), shown in
Figure 10, and adjust the backstop (G) to the
desired angle. Re-tighten lock lever (F).
Figure 11 shows an angle tenon procedure with
the fence tilted. Loosen lock lever (H) to tilt the
fence.
This type of cut requires a
spacer (J) between the workpiece and the
fence in order to prevent the saw blade
coming into contact with the fence.
Figure 9
Figure 10
Figure 11
Parts
Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call
800-274-6848 between 7:00 a.m. and 6:00 p.m. (CST), Monday through Friday. Having the Model
Number and Serial Number of your machine available when you call will allow us to serve you quickly and
accurately.