Filter
Top Products
3
SECTION 1
INTRODUCTION
This manual attempts to provide all of the information necessary for the safe and proper installation, operation and
maintenance of Presto’s Battery Operated Work Positioner. It is important that all personnel involved with the
installation, maintenance or operation of the Work Positioner read this manual. Additional manuals are available at
www.prestolifts.com
The battery-operated Work Positioner is equipped with a data plate that has a serial number and model identification.
Please refer to these numbers when ordering parts or requesting further information.
The battery-operated Work Positioner is designed for lifting, lowering and positioning a wide variety of loads. Call
Presto for further instructions where unique situations arise that are not covered in this manual.
The battery-operated Work Positioner is designed for only indoor, non-hazardous locations. These units are not for
personnel lifting. All equipment is manually propelled and has a hydraulically powered vertical travel.
SECTION 2
SAFETY
The battery-operated Work Positioner is a very powerful lift capable of doing large amounts of work.
Carefully read this manual before installing or operating this lift. Some hazards have been identified that may occur
during the installation, maintenance and use of this lift.
WARNING!
• Do not perform any repair work on lifts if there is a load on the forks or platform.
• Do not perform any repair work if the forks or platform is in the raised position.
• All personnel must stand clear of the lift while in motion.
• Do not put hands or feet under the forks or platform.
• Do not stand underneath the forks or platform.
• Do not stand in front of the Work Positioner while in motion.
• Do not stand, sit or climb on the lift.
• Do not use the lift on soft, uneven or unstable surfaces.
• Do not exceed the load center or capacity.
SECTION 3
INSTALLATION
A. INSPECTION:
The lift is tested and inspected prior to shipment. Inspect the Work Positioner completely upon receipt, to determine if
there is any damage caused during shipment by the freight company and that the lift is complete. A freight claim must
be filed with the freight company if damage is apparent. Do Not use the lift if there appears to be any damage. Check
the following with the lift in a collapsed position: