Filter
Top Products
Python
®
Lincoln Compatible
™
Owner's Manual - Page 3
table top, with the other hand give
the Removal Tool a quick snap-turn
in the CLOCKWISE DIRECTION.
3. Once the drive roll is loose,
continue to spin drive roll in the
clockwise direction to remove the
drive roll from the gun.
4. Install a new drive roll on the left-hand threaded shaft. The drive roll will
self-tighten when it is feeding wire.
Idler Roll Installation and Removal
(Reference Figure 3)
1. Using a slot type screwdriver, loosen idler screw, taking care not to lose
lock washer under idler roll.
2. Insert new idler roll and lock washer onto screw, insuring that idler groove
is toward top and lock washer is beneath.
3. Tighten.
NOTE: Lock washer must be under idler roll or it will not turn freely.
Section C Accessories/Options
Insulated Drive Roll Kits are used to prevent preheating of the wire which
may soften it and clog the liner. This picking up of current at the drive rolls
rather than at the contact tip is usually not a problem unless using too large
of a contact tip or excessively oxidized aluminum wire.
Insulated Groove Drive Roll Kit ..................................................... 005-0640
For .030" (0.8mm) dia. aluminum wire. Includes insulated groove drive roll
and insulated idler roll assy.
Insulated Groove Drive Roll Kit ..................................................... 005-0716
For .035" (0.9mm) dia. aluminum wire. Includes insulated groove drive roll
and insulated idler roll assy.
Insulated Groove Drive Roll Kit ..................................................... 005-0642
For .040" (1.0mm) dia. aluminum wire. Includes insulated groove drive roll
and insulated idler roll assy.
Insulated Groove Drive Roll Kit ..................................................... 005-0718
For 3/64" (1.2mm) dia. aluminum wire. Includes insulated groove drive roll
and insulated idler roll assy.
Insulated Groove Drive Roll Kit ...................................................... 005-0644
For .062" (1.6mm) dia. aluminum wire. Includes insulated groove drive roll
and insulated idler roll assy.
Handle Kit.........................................................................................005-0699
Includes left and right handles, screws and drive roll door.
Figure 3
Figure 2