Filter
Top Products
StorNext 3.5.1 Upgrade Guide
Document 6-01620-10 Rev A
June 2009
Upgrading to StorNext 3.5.1 (SNFS Only) 10
(Optional) After upgrading, restore the previous client configuration (see
Restoring a Previous Client Configuration on page 14).
Removing a Previous Version of StorNext 0
If a previous version of StorNext older than version 3.0 exists on the system, you
must remove it before installing the new version. If you are upgrading from a
version of StorNext newer than version 3.0, the old client configuration is retained
so there is no need to restore the old configuration.
1 Insert the StorNext installation CD.
2 Browse to the root directory of the installation CD and double-click the file
SnfsSetup64.exe (64-bit systems).
The StorNext Installation window appears (figure 4).
Figure 4 StorNext Installation
Window: Remove StorNext
3 Click Remove StorNext.
A dialog box appears informing you that the current client configuration has
been saved.
4 Note the name and location of the saved configuration file, and then click OK.
5 If prompted, click Yes to continue, and then click OK to finish the removal.
6 When the removal is complete, click Yes to reboot the system.
Running the Setup Wizard 0
To launch the setup wizard, use the correct StorNext installation CD for your
operating system.
1 Insert the StorNext installation CD.
Note: You must log on as an Administrator to install StorNext.
Note: After installing the new version of StorNext, you can restore the saved
client configuration (see
Restoring a Previous Client Configuration on
page 14).