Filter
Top Products
• ALL BOILERS MUST BE INSTALLED IN ACCORDANCE WITH NATIONAL, STATE AND
LOCAL PLUMBING, HEATING AND ELECTRICAL CODES AND ORDINANCES, AS WELL AS
THE REGULATIONS OF THE SERVING ELECTRICAL, WATER AND GAS UTILITIES.
• Improper installation, adjustment, or maintenance of this boiler can cause property damage, personal injury
or death. Due to this fact only experienced technicians and installers may install or adjust BIASI boilers.
All systems should be designed by competent contractors, and only persons knowledgeable in the layout
and installation of heating systems should attempt the installation of any boiler. The homeowner should
never tamper with any part of the boiler.
• Thoroughly read and understand all instructions including the B-10 or SG atmospheric venting instructions
before beginning this installation.
• After installation place this manual in a safe place in plain view of the boiler. If the manual is no longer
legible contact QHT I NC. for a new manual.
• After the boiler is installed and in working order, it should be serviced once a year before each heating
season. Service on the boiler may only be done by an experienced installer or oil heating technician.
• These boilers may only be direct vented using approved venting systems supplied through QHT INC. For
the boiler warranty, please consult the B-10 or SG atmospheric venting manual.
•
Do not burn volatile garbage, gasoline, naphtha or other flammable liquids other
than No. 2 fuel oil. All flammable liquids (especially gasoline), chemicals, rags,
paper, wood scraps, debris, etc., should be kept away from the boiler at all times.
Keep the boiler area clean and free of all fire hazards.
• Please read the literature and warranties supplied by the manufacturers of the various accessory equipment.
This equipment is warranted by the respective manufacturers, not by Quincy Hydronic Technologies, Inc.
Each piece of equipment must be installed and used according to the recommendations of the manufacturer
WARNING
2