Radio Shack 20-136 PRO-136 Sander User Manual


 
10
Scanner Setup
2. The hour digits flash. Press T or S or press the number keys to enter
the hour. Then press ENT/PROGRAM to set.
3. The minutes digits flash. Press T or S or press the number keys to enter
the minutes. Press ENT/PROGRAM to set.
Note: When setting the clock minutes, the seconds digits are reset
to 00 to enable accurate time adjustment.
4. AM/PM flashes. Press T or S to select
AM or PM. Press ENT/PROGRAM to set.
5. To save your selection, slide the Clock
Switch to Clock.
6. To set the alarm, slide the Clock Switch
to Alarm Set and repeat steps 2-5.
Alarm Function
Slide the Alarm Switch to Tone, if you want the alarm to sound a tone
at the set time.
Slide the Alarm Switch to Radio if you want the alarm to sound with
the channel that was previously selected in Scan Mode. The radio
alarm will only sound in Standby Mode.
To silence the alarm, slide the Alarm Switch to Off. If you do not turn
off the alarm, it will sound for 20 minutes then reset to alert you again
the following day.
Programming Frequencies into Channels
Before the scanner can begin to scan, you must program a frequency into at
least one channel.
To locate and store specific frequencies into channels for later use:
1. From Scan Mode, press SCAN/MAN to stop scanning.
2. Press ENT/PROGRAM to put the scanner in programming mode. PGM
appears.
3. Use the number keys to enter both the channel storage bank and the
channel number you want to assign to a frequency.
4. Press SCAN/MAN.