Filter
Top Products
US-9
SGCZ2450S
U
S
6. Set up
■ MOUNTING ENGINE (SE1)
1. Install the engine to the driveshaft so
that the cylinder head and the stop
switch may come on the same side.
2. Using attached four bolts, secure the
connection firmly with equal force
(Torque: 25in-lbs)(Torque: 2.8 N.m.).
(1) Bolt
(2) Stop switch
Never use any screws other than those
specified by the manufacturer, or the
engine can get loose, resulting in a
hazardous event.
Tighten the screws gradually by turns.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to
the joint on the top of the carburetor.
(SE2)
■ CONNECTING SWITCH WIRES
• Connect the switch wires between the
engine and the main unit. Pair the wires
of the same color.
■ INSTALLING HANDLE
• Mount the handle to the shaft tube and
clamp it at a location that is comfortable
to you. (SE3)
(1) About 48cm
IMPORTANT
WARNING
SE1
SE2
SE3
SE4
SE5
SE6
■ CUTTERCASE (SE4)
The blade has very sharp edges. Be
sure to use protective gloves
whenever handling it.
1. Remove the fastening screw(long) and
the lock screw(short) from the
cuttercase.
2. While aligning the locking holes, install
the cuttercase assembly to the shaft
casing.
3. Align the locking holes and screw in the
lock screw to the bottom by hand, then
secure it with the wrench provided. Do
not tighten up the lock screw with the
holes out of alignment, or the
cuttercase can be damaged.
(1) Cuttercase
(2) Locking holes
If the locking screw is tightened up with
the holes out of alignment, the cuttercase
may be damaged.
4. Fasten the cuttercase fastening screw.
■ BLADE GUARD
Install the blade guard onto the shaft
casing approx. 3cm away from the
cuttercase. Fasten the clamp uniformly.
(SE5, SE6)
NOTE
WARNING