Filter
Top Products
machine control.
3. Since the blade does not cause cut grass to
wrap around the neck, you need not to stop
operation to remove such wrappers.
What's more, since the whole circle of the blade is
available for cutting, you can move the cutting
head in all directions and cut grass growing on
such place difficult-to-get with conventional
trimmer.
You can even trim the waterside without splashing
water.
■ CUTTING WORK
1. Always wear eye protection such as safety
goggles. Never lean over the rotating cutting
head. Rocks or other debris could be thrown
into eyes and face and cause serious
personal injury.
2. Keep the debris guard attached in place at
alltimes when the unit is operated.
• Adjust the front handle to the most comfortable
position.
• Start the engine and pull the throttle lever
gradually. The blades will start moving as the
engine speed goes up.
• To stop the blade motion, simply release the
throttle lever. The clutch will disengage and the
blades stop moving while the engine keeps
idling.
• Move the cutting head as sliding its bottom on
the ground. This will help you do the job with
less effort.
• Avoid running the engine at full throttle with no
load. Continuous no load full throttle operation
can cause damage to the engine and driveshaft.
• Operation at too slow engine speed can cause
abnormal vibration of the machine, resulting in
short life of driveshaft and clutch parts. If you felt
such vibration, use a higher speed range.
• Though the blades are made of harder steel
compared to conventional metal blades,
continuous cutting in soil will accelerate wear.
NOTE
WARNING
7. Operation
❲
18
❳
RECOMMENDED APPLICATIONS:
Parking area
Among trees
Near fences
Road side
Road edge
Water side
Aroud stones