Filter
Top Products
31
Rabbeting
Rabbeting is very similar to jointing except that only part
of the edge is jointed. Do not remove the guard for rab-
beting. To rabbet hold the workpiece firmly against the
fence. Do not make cuts greater than 1/8". To make a
deeper rabbet, make cuts in 1/8" deep increments.
Because the workpiece is supported by the outfeed table
during a rabbet cut, the infeed table must be lowered
after each pass.
Stop Pin Operation
A stop pin (item #13 page 19) is supplied to prevent
against planing or jointing more than 1/8" depth of cut.
Planing and jointing operations greater than 1/8" per
pass are not recommended. Rabbeting operations
greater than 1/8" can be performed by pulling the stop pin
out and lowering the infeed table in 1/8" increments. The
pin automatically resets when you return to the 0" to 1/8"
depth of cut range. Never cut a full 1/2" rabbet in one cut.
Cut in 1/8" depth increments until your full depth is
acquired.
Support Long Workpieces
To reduce the risk of injury from slips or kickbacks, use
extra supports (tables, saw horses, etc.) at both infeed
and outfeed ends if your workpiece if hard to hold down
to the table.
Using the Hold-Down/Push-Blocks
Always use the hold-down/push-blocks whenever possi-
ble when jointing or rabbeting wood.
Grasp the hold-down/push-blocks firmly with the fingers
close together and wrapped around the handle. Position the
hold-down/push-blocks flat, on top of workpiece and push
the workpiece down against the table. This helps to provide
a quality cut and minimize the chance of a kickback.
Hold-down pressure must also be sufficient to prevent
hold-down/push-block from sliding or slipping on the top
face of workpiece when advancing workpiece over cutter-
head.
Use a hand-over-hand motion of the hold-down/push-
blocks, being careful to maintain control over the work-
piece at all times.
This means that once the workpiece has been fed past
the cutterhead onto the outfeed table, one hold-down/
push-block must always maintain contact with the work-
piece on the outfeed table.
Face
Edge
End
Rabbet