Filter
Top Products
26
27
n Slowly lower the blade into and through the workpiece.
n Release the switch trigger and allow the saw blade to stop
rotating before raising the blade out of workpiece. Wait
until the electric brake stops blade from turning before
removing the workpiece from miter table.
TO COMPOUND MITER CUT
A compound miter cut is a cut made using a miter angle and
a bevel angle at the same time. This type of cut is used to
make picture frames, cut molding, make boxes with sloping
sides, and for certain roof framing cuts.
To make this type of cut the control arm on the miter table
must be rotated to the correct angle and the saw arm must
be tilted to the correct bevel angle. Care should always be
taken when making compound miter setups due to the in-
teraction of the two angle settings.
Adjustments of miter and bevel settings are interdependent
with one another. Each time you adjust the miter setting you
change the effect of the bevel setting. Also, each time you
adjust the bevel setting you change the effect of the miter
setting.
It may take several settings to obtain the desired cut. The
first angle setting should be checked after setting the second
angle, since adjusting the second angle affects the first.
Once the two correct settings for a particular cut have been
obtained, always make a test cut in scrap material before
making a finish cut in good material.
n Pull out the lock pin and lift saw arm to its full height.
n Loosen the miter lock handle. Rotate the miter lock han-
dle approximately one-half turn to the left to loosen.
n Press the miter lock plate down with your thumb and
hold.
n Rotate the control arm until the pointer aligns with the
desired angle on the miter scale.
n Release the miter lock plate.
NOTE: You can quickly locate 0°, 15
°
, 22.5
°
, 31.62
°
, and
45° left or right by releasing the miter lock plate as you
rotate the control arm. The miter lock plate will seat itself
in one of the positive stop notches, located in miter table
frame.
n Tighten the miter lock handle securely.
n Loosen the bevel lock knob and move the saw arm to
the left to the desired bevel angle.
n Bevel angles can be set from -2˚ to 48˚.
n Once the saw arm has been set at the desired angle,
securely tighten the bevel lock knob.
n Make a test cut in scrap material.
n Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board could collapse on the blade at the end of the
cut, jamming the blade. See Figures 37 - 38.
n When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table. See Figure 35.
Fig. 33
WORK CLAMP
OPERATION
COMPOUND
MITER CUT