Filter
Top Products
18
18
WARNING:
Make sure the spindle lock button is not engaged
before reconnecting saw to power source. Never
engage spindle lock button when blade is rotat-
ing.
INSTALLING / REPLACING THE BLADE
See Figure 13.
WARNING:
A 12 in. blade is the maximum blade capacity of
the saw. Never use a blade that is too thick to allow
outer blade washer to engage with the flats on the
spindle. Larger blades will come in contact with the
blade guards, while thicker blades will prevent the
hex bolt from securing the blade on the spindle.
Either of these situations could result in a serious
accident and can cause serious personal injury.
Unplug the saw.
Raise saw arm.
Rotate lower blade guard up and loosen screw. Rotate
blade bolt cover up and back to expose the hex bolt.
Depress the spindle lock button and rotate the hex bolt
until the spindle locks.
Using the wrench provided, loosen and remove the hex
bolt.
NOTE: The hex bolt has left hand threads. Turn hex bolt
clockwise to loosen.
Remove the washer, outer blade washer (or laser guide),
and the blade. Do not remove the inner blade washer.
Wipe a drop of oil onto the inner blade washer and the
outer blade washer (or laser guide) where they contact
the blade.
WARNING:
If inner blade washer has been removed, replace
it before placing blade on spindle. Failure to do
so could cause an accident since blade will not
tighten properly.
Fit saw blade inside lower blade guard and onto spindle.
The blade teeth point downward at the front of saw as
shown in figure 13.
Fig. 13
ASSEMBLY
LOWER
BLADE
GUARD
BLADE
SCREW
BLADE
BOLT
COVER
FLAT
ON SPINDLE
INNER BLADE
WASHER WITH
DOUBLE “D” FLATS
OUTER BLADE
WASHER
TO
LOOSEN
TO
TIGHTEN
HEX
BOLT
SCREW
CAUTION:
Always install the blade with the blade teeth and
the arrow printed on the side of the blade pointing
down at the front of the saw. The direction of blade
rotation is also stamped with an arrow on the upper
blade guard.
Replace outer blade washer (or laser guide). The double
“D” flats on the blade washers align with the flats on the
spindle.
Depress spindle lock button and replace the washer and
hex bolt.
NOTE: The hex bolt has left hand threads. Turn blade
bolt counterclockwise to tighten.
Tighten hex bolt securely.
Replace the lower blade guard and blade bolt cover.
Retighten the screw securely.
WASHER