Filter
Top Products
8
9
ASSEMBLY
WARNING:
The tool should never be connected to a power
supply when you are assembling parts, making
adjustments, cleaning, performing maintenance,
or when the tool is not in use. Disconnecting the
tool will prevent accidental starting that could
cause serious injury.
This saw has been shipped completely assembled except
for the blade. Inspect it carefully to make sure no break-
age or damage has occurred during shipping. If any parts
are damaged or missing, contact your nearest retail store
to obtain replacement parts before attempting to operate
saw. A blade, vacuum attachment, and this owners manual
are also included.
WARNING:
If any parts are missing, do not operate this tool
until the missing parts are replaced. Failure to un-
plug your saw could result in accidental starting
causing possible serious injury.
To Install Jig Saw Blades
See Figure 2.
Unplug your saw.
Remove the chip shield and the splinter guard by sliding
it forward.
Push the clamping lever on the rapid-change clamp
until it stops.
Holding the clamping lever open, insert the saw blade
as far as possible into the slot in the saw bar.
Check to make sure the back of the saw blade is
centered in the groove of the roller guide.
Release the clamping lever. Make sure the blade is
securely in place.
Replace the chip shield. Replace the splinter guard, if
applicable.
SAW BLADE
Fig. 2