Filter
Top Products
19
OPERATION
TO ADJUST 0° BEVEL STOP
See Figures 16 and 17.
Unplug the saw.
Pull bevel adjustment lever upward to release.
Turn set screw with hex wrench and adjust base until it
is square with the saw blade.
Securely lock the bevel adjustment lever.
TO ADJUST BEVEL SETTING
See Figure 16.
Unplug the saw.
Pull the bevel adjustment lever upward until the motor
housing moves freely.
Raise the motor housing end of the saw until you reach
the desired angle setting on the bevel scale (0-45°).
NOTE: Pull the adjustment lever all the way up to set the
angle at 51.5°. To reach the 51.5° bevel setting, push
the 51.5° bevel button.
Press downward on the bevel adjustment lever until the
motor housing is securely locked in place.
Fig. 17
SET
SCREW
Fig. 16
BEVEL
ADJUSTMENT
LEVER
51.5° BEVEL
BUTTON