Filter
Top Products
21
Fig. 20
LENGTH OF CUT
SCALE
LENGTH OF CUT SCALE
See Figure 20.
The saw is equipped with a length of cut scale on its base. It
is parallel with the saw blade and you can use it to measure
the distance the blade cuts into the material.
NOTE: Six inches is the maximum length of cut that you can
measure. Also, it is accurate only when the depth of cut is
set at full maximum depth.
OPERATION
ADJUSTMENTS
ADJUSTING THE LEVER LOCK MECHANISM
See Figure 21.
The lever lock mechanism located at the bevel bracket and
at the base of the elevation bracket may be adjusted to the
degree of leverage the operator prefers.
Pull the lever upward until it is fully loosened.
Gently pry the retaining clip from the cap nut with a small
flat blade screwdriver. Save the retaining clip.
Pull the lever off the cap nut and adjust the lever loca-
tion.
Tighten the lever to check for desired tightness.
If this is the desired tightness, then reinstall the retaining
clip on the cap nut, using a flat blade screwdriver to tap
it into place.
NOTE: Reinstall the retaining clip with the bow up.
If the lever is not tight enough, repeat the above steps.
Fig. 21