Filter
Top Products
10
11
INSTALLING THE PIPE HANDLE
See Figure 2.
n
Unplug the drill.
n
Insert the pipe handle into the 3/4 NPT threaded hole on
the side of the drill.
n
Turn the handle clockwise to securely hand-tighten the
handle.
n
The pipe handle may be installed either on the left or right
side of the drill.
INSTALLING BITS
See Figures 3 - 4.
n
Unplug the drill.
n
Insert the chuck key provided and twist counterclock-
wise.
n
Insert the drill bit into the chuck the full length of the
jaws.
WARNING:
Do not insert drill bit into chuck jaws and tighten as
shown in figure 4. This could cause the drill bit to
be thrown from the drill resulting in possible serious
personal injury or damage to the chuck.
n
Tighten the chuck jaws securely on the drill bit, turning
clockwise with the chuck key provided. Do not use a
wrench to tighten or loosen the chuck jaws. For best per-
formance, repeat this for the remaining two key holes.
n
Remove the chuck key and return it to the key strap.
REMOVING BITS
n
Unplug the drill.
n
Loosen the chuck jaws using the chuck key provided.
See “Installing Bits.”
n
Remove the drill bit from the chuck jaws.
n
Remove the chuck key and return it to the key strap.
Fig. 2
ASSEMBLY
Fig. 3
Fig. 4
PIPE HANDLE
CHUCK
KEY
BIT
TO
LOOSEN
TO
TIGHTEN
INCORRECT