Filter
Top Products
10
11
OPERATION
WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.
APPLICATIONS
You may use this tool for the purposes listed below:
n Drilling in wood
n Drilling in both hard and soft metals
SETTING THE POSITION OF THE BAIL HANDLE
See Figure 5.
The bail handle may be adjusted to three positions, depend-
ing on the application and the angle that will give you most
control and best access to the workpiece.
To set the position of the bail handle:
n Using a 14 mm wrench, loosen the hex head screw on
each side of the tool by turning counterclockwise. It is
not necessary to remove the screws.
n Adjust the handle forward or back until the desired posi-
tion is reached.
n Tighten the screw on each side by turning the wrench
clockwise. Do not overtighten.
Fig. 5
HEX HEAD
SCREW
BAIL HANDLE
WRENCH